Pressing
the
decompression
valve
4.
Hold
the saw firmly
on
the ground with your left hand
around the handlebar (6) and put the toe of your right
foot into the rear handle and press down.
5.
Press the decompression valve (7) with the
th
umb
of
your left hand. Pull the starter grip (8) slowly with your
right hand until you feel the starter engage and then
give
~
a brisk strong pull.
The starter rope should not be pulled out more than
70
em
(27 in) as there is otherwise a risk of it breaking.
Do
not allow starter grip (8) to snap back. Guide it back
vertically so that the starter rope can rewind correctly.
6.
As
soon as the engine is running, release the decom-
pression valve
(7) and immediately disengage the start-
ing
throttle lock
(5)
by briefly squeezing the throttle
trigger so that the engine can settle down
to
idle speed.
7.
To
stop the engine, flick the stop switch (2) to the
"STOP"
position.
Top:
51.rting
Center:
Idle
position
Bottom:
S10p
switch
In
"STOP"
position
*"
__
8
•
,
25
To Next Page
Loading...
Need help?
General
