Page 18 Technical Information 08.2005
TI_08_2005_11_01_02.fm
5.6 Mounting the blower tube and arrester
. Clip the sleeve on the arrester into the holder
(arrow).
. Run the arrester (1) through the blower tube (2).
. Shove blower tube (3) onto blower tube (2), and
lock the buttons (4)
. Run the arrester (1) through the sliding ring (5).
. With its wide lip facing left, shove the sliding
ring (5) onto the blower tube end section (2).
. Run the arrester (1) through the hose clip (6)
(hose clip without the retention groove for the
throttle cable) – screw head facing forward.
. Run the arrester (1) through the pleated
hose (7).
. Shove the blower tube (2) into the pleated
hose (7).
. Tighten the hose clip (6) with the screw (8).
To Next Page
Loading...
