Technical Information 08.2005 Page 19
TI_08_2005_11_01_02.fm
. Run the arrester (1) through the pleated hose
(7) and hose clip (9) (hose clip with the retention
groove for the throttle cable) – screw head and
retention groove facing forward.
. Shove the hose clip (9) onto the pleated
hose (7).
. Hook the discharge wire hook (1) in the
loop (10).
. Shove the pleated hose (7) with the hose clip (9)
in the shown position over the manifold (11).
. Tighten down the screw (12).
. Shove nozzle (13) (depending on the market
region) onto blower tube (2), and lock the
buttons (14).
Only operate the device when the arrester is
correctly mounted.
Check the following:
. The hook on the arrester is always in the loop
(arrow)
. The sleeve on the arrester is always clipped in
the holder (arrow)
To Next Page
Loading...
