Page 20 Technical Information 08.2005
TI_08_2005_11_01_02.fm
5.7 Adjusting the throttle cable
After assembling the blower or after it has been
operated for a long time, the throttle cable may have
to be readjusted.
The throttle cable may only be adjusted when the
blower is completely assembled.
. Pull the throttle trigger all the way back.
. Carefully turn the screw in the throttle trigger
until it starts to encounter resistance.
5.8 Install tank vent
Tank vents must not be reused.
. Moisten the O-ring and bead with STIHL press
fluid.
. Centre the tank vent in the hole.
. Press in the tank vent until it locks; it must
audibly snap in.
To Next Page
Loading...
