Technical Information 08.2005 Page 21
TI_08_2005_11_01_02.fm
5.9 Replace the pick-up body
Removal
. Remove the shroud with rewind starter
. Clean the connecting element (1) and
surrounding area.
. Carefully pry out the connecting element (1) with
the hoses and pick-up body.
. Replace the pick-up body.
Installation
Do not confuse the hose for the fuel return (2) and
suction hose (3):
The suction hose (3) has a larger inner diameter and
is connected to the hose for the pick-up body (4).
. Always use a new seal (5).
. Coat the entire seal with STIHL press fluid.
. The removal tab on the connecting element
(arrow) must lie in the recess of the fuel tank.
. Press in the connecting element until it locks; it
must audibly snap in.
To Next Page
Loading...
