BF-KM
English
10
Only use KombiEngines supplied by
STIHL or expressly approved by STIHL
for use with the KombiTool.
This KombiTool may be operated only in
combination with the following
KombiEngines:
STIHL KM 55 R, KM 56 R, KM 85 R,
KM 90 R, KM 110 R, KM 130 R
WARNING
Loop-handled machines must be
equipped with a barrier bar.
This KombiTool may also be mounted to
STIHL brushcutters (basic power tools)
with a split drive tube (T models).
Operation of this KombiTool is therefore
also permitted on the following power
tool models:
STIHL FS 55 RT, FS 83 RT, FS 85 RT
WARNING
Please refer to the power tool's
instruction manual regarding to use of
the barrier bar.
N Pull the protective caps off the ends
of the drive tube and keep them in a
safe place for later use – see
"Storing the Machine".
NOTICE
The plug may come out of the drive tube
when you pull off the cap. Push it back
into the drive tube as far as stop.
Mounting the deflector
N Slide the deflector (1) onto the drive
tube (2) until distance "a" is 4 in
(100 mm).
N Line up the deflector (1) so that it is
vertical and the fixing lug (arrow) on
the drive tube points up.
N Tighten the clamp screw (3)
moderately.
NOTICE
Check that the deflector is secure – it
must not be possible to rotate it on the
drive tube.
Approved KombiEngines Assembling the Unit
To Next Page
Loading...
Need help?
General
