Stihl BG 50 - Page 15

BG 50
English
13
N Move the choke lever (3) to f.
N Pull the throttle trigger (2) and hold it
there.
N Continue cranking until the engine
runs.
N Wait 10 seconds, then move the
choke lever (3) to e.
If the engine is warm
Also use this setting if the engine has
been running but is still cold.
N Move the choke lever (3) to f.
N Pull the throttle trigger (2) and hold it
there.
N Continue cranking until the engine
runs.
N Wait 10 seconds, then move the
choke lever (3) to e.
Cranking
N Place the unit on the ground so that
it is secure.
N Make sure you have a firm footing:
Hold the unit firmly with your left
hand on the housing and press
down.
N Hold the starter grip with your right
hand.
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Starting the Engine – Version B
N Observe safety precautions.
N Press the fuel pump bulb at least
five times – even if the bulb is
already filled with fuel.
N Move the stop switch (1) to the run
position I
Setting the choke lever
If the engine is cold
N Move the choke lever (3) to g
0000-GXX-0617-A0
3
295BA016 KN
0075BA003 KN
2
1
0075BA002 KN
3
0000-GXX-2832 A0