BR 500, BR 550, BR 600
English
18
N Push the setting lever (1) upwards.
The throttle trigger (2) is in the full
throttle position.
N Move the setting lever (1) to C.
N Engage the throttle trigger (2) in the
full throttle position.
N Continue cranking until the engine
runs.
Other Hints on Starting
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
N Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
Engine stalls in cold start position c or
under acceleration
N Move the choke knob to o and
continue cranking until the engine
runs.
Engine does not start in warm start
position o
N Move the choke knob to c and
continue cranking until the engine
runs.
Fuel tank run until completely dry
N After refueling, press the manual
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
N Set the choke knob according to
engine temperature.
N Now start the engine.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This helps protect engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Keep the machine
in a dry place, well away from sources of
ignition, until you need it again. For
longer out-of-service periods – see
"Storing the Machine".
2
1
0000-GXX-1401-A0
0000-GXX-1402-A0
Operating Instructions
To Next Page
Loading...
