11BT 121
English / USA
Mounting the Auger Brake Lever
: Place the activating lever (1) in the
retainer.
: Fit the clamp (2) on the activating
lever.
: Insert the screws (3) and tighten
them down firmly.
Fitting the Padding
: Attach the holders (2) of the padding
(1) to the slots in the handle frame.
: Swing the padding upwards and
secure it to the handlebar with the
hook-and-loop strips (3).
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
Assembling the Machine Adjusting the Throttle
Cable
002BA163 KN
To Next Page
Loading...
