4.3 Edging
► Start the engine
► Start the cut at no less than half throttle and
continue cutting at full throttle.
► Hold and guide your power tool so that the
blade is vertical.
► Cut steadily so that the engine is not lugged
down – do not apply force.
► Operate at no more than a normal walking
pace.
► Do not push the blade into the ground.
► Always walk forwards when cutting, do not pull
the unit towards you.
► Cut at a steady pace to avoid having to make
several passes.
► Use the gunning sight (1) to line the blade up
with the edge of the bed.
5 Approved KombiEngines
5.1 KombiEngines
Only use KombiEngines supplied or explicitly
approved by STIHL for use with the attachment.
This KombiTool may be operated only in combi‐
nation with the following KombiEngines:
STIHL KM 56 R, KM 85 R, KM 94 R, KM 111 R,
KM 131, KM 131 R, KM 235.0 R, KMA 130 R,
KMA 135 R, KMA 80.0 R, KMA 120.0 R
WARNING
Loop-handled machines must be equipped with
a barrier bar.
5.2 Brushcutters with split boom
The KombiTool can also be mounted on STIHL
brushcutters with a split shaft (T-models) (basic
power tools).
Operation of this KombiTool is therefore also
permitted on the following power tool models:
STIHL FR 131 T
English 5 Approved KombiEngines
8 0458-471-0121-C
To Next Page
Loading...
Need help?
General
