Stihl FCB-KM - Assembling the Unit; Mounting the Kombitool

WARNING
Refer to the power tool's User Manual for how to
use the barrier bar.
6 Assembling the Unit
413BA014 KN
► Pull the protective caps off of the ends of the
shaft and keep them in a safe place for later
use – see "Storing the Machine"
6.1 Connecting drive tube to gear‐
box
1
239BA018 KN
2
► Loosen the clamping screw (1) on the gearbox
– do not remove
► Insert curved end of drive tube (3) in the gear‐
box (2), turn the gearbox back and forth as
necessary.
► Push the shaft (3) in as far as it will go.
► Screw in the clamping screw (1) as far as it will
go – do not tighten yet!
2
239BA019 KN
4
► Align the gearbox (2) on the shaft so that the
rib (4) is in line with the shaft.
► Tighten the clamping screw firmly.
7 Mounting the KombiTool
1
002BA326 KN
2
► Push the lug (1) on the drive tube into the
slot (2) in the coupling sleeve as far as stop.
3
002BA327 KN
4
6 Assembling the Unit English
0458-471-0121-C 9