Stihl FS 100 RX User Manual

FS 100 RX
English
18
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut C 25-2,
STIHL TrimCut 31-2, STIHL FixCut 25-
2, STIHL PolyCut 20-3
N Screw the mowing head
counterclockwise on to the shaft (1)
as far as stop.
N Block the drive shaft.
N Tighten down the mowing head.
Remove the tool used to block the shaft.
Removing the mowing head
N Block the drive shaft.
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut C 25-2,
STIHL TrimCut 31-2, STIHL FixCut 25-
2, STIHL PolyCut 20-3
N Unscrew the mowing head
clockwise.
Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
the remaining line is still at least 21/2in.
(6 cm) long. The blade on the deflector
trims surplus line to the correct length.
STIHL AutoCut
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 11/4in (3cm)
fresh line is advanced.
The blade on the deflector trims surplus
line to the correct length – avoid tapping
the mowing head more than once at a
time.
Line feed operates only if both lines still
have a minimum length of 1 in (2.5 cm).
All other mowing heads
Refer to the instructions supplied with
the mowing head.
To reduce the risk of injury, always shut
off the engine before adjusting the
mowing line by hand.
Replacing Nylon Line or Cutting Blades
Refer to the instructions supplied with
the mowing head.

Stihl FS 100 RX Specifications

General

Brand	Stihl
Model	FS 100 RX
Category	Trimmer
Language	English