FS 120, FS 120 R, FS 250
English
28
If the engine still does not start
N Push the slide control in the
direction of the arrow on the stop
symbol (h) to STOP-0.
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Open the throttle wide.
N Crank the engine several times with
the starter to clear the combustion
chamber.
N Refit the spark plug – see "Spark
Plug".
N Move the slide control to START.
N Set the choke knob to e – even if
the engine is cold.
N Start the engine.
Throttle Cable Adjustment
N Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
Fuel tank run until completely dry
Recommendation: Carry out the
following steps irrespective of the
engine's operating condition before the
tank was run dry.
N After refueling, press the manual
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
N Turn the choke knob to g.
N Go to section on "Starting" and re-
start the engine as described for a
cold engine.
Using Transport Guard
The type of transport guard depends on
the metal cutting attachment supplied
with the machine. Transport guards are
available as special accessories.
230 mm Grass Cutting Blades
250 mm Brush Knives
Transporting the Unit