44
English / USA
FS 120, FS 120 R, FS 200, FS 200 R, FS 250, FS 250 R
For periods of about 3 months or longer
: Drain and clean the fuel tank in a
well ventilated area.
: Dispose fuel properly in accordance
with local environmental
requirements.
: Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
: Remove, clean and inspect the
cutting tool.
: Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
: Use a file (special accessory) to
sharpen cutting tools. In case of
more serious wear or nicks:
Resharpen with a grinder or have
work done by STIHL dealer.
: Resharpen frequently, take away as
little material as possible – two or
three strokes of the file are usually
enough.
To avoid out-of-balance
: After resharpening about 5 times,
have blade checked on STIHL
balancer (special accessory) and
rebalanced as necessary.
: Resharpen the cutters (1) uniformly
– do not alter the contour of the
parent blade (2) in any way.
See cutting tool packaging for additional
sharpening instructions.
Storing the Machine Sharpening
Metal Cutting Tools
2
2
1
2
1
1
002BA042 KN
To Next Page
Loading...
