FS 38
English
29
Preparations
N Shut off the engine.
N Put the machine on the ground with
the mowing head facing up.
Removing remaining nylon line
N Open the mowing head – hold it
steady with one hand.
N Turn the cap (1) counterclockwise.
N Disengage the spool (2), take it out
of the mowing head and remove the
remaining line.
Winding line onto spool
A prewound spool (special accessory)
may be used as an alternative to the
following procedure.
N Use green-coded nylon line with a
diameter of 2.0 mm (0.08 in).
N Cut two 3 m (10ft) lengths of nylon
line from the reel (special
accessory).
N Insert the ends of each line (3) in the
holes (4) in the spool.
N Bend the ends of the lines over the
edge of the holes to form a hook.
N Straighten out the nylon lines and
wind them tightly on to the spool –
one nylon line in each chamber.
N Engage the ends of the lines in the
notches (2).
Assembling the mowing head
NOTICE
Check that the compression spring is
installed (see "Mounting the Mowing
Head").
To Next Page
Loading...
