D
Darren WeaverSep 7, 2025
How to fix ball bearing of the clutch drum is damaged on Stihl Brush Cutter?
- AAmy YoungSep 8, 2025
Replace ball bearing.
How to fix ball bearing of the clutch drum is damaged on Stihl Brush Cutter?
Replace ball bearing.
What to do if my Stihl FS 410 Brush Cutter engine runs rough and misfires?
If your Stihl Brush Cutter engine runs roughly, misfires, or experiences temporary power loss, the spark plug boot may be loose. Press the boot firmly onto the spark plug and fit a new spring if necessary.
Why won't the starter rope rewind on my Stihl FS 410 Brush Cutter?
If the starter rope does not rewind, heavy fouling or rust may be present on the rewind spring. Clean or replace the rewind spring.
Why does the cutting attachment on my Stihl Brush Cutter stop under load?
If the cutting attachment stops under load at full throttle, it could be because the clutch shoes or clutch drum are badly worn. Install a new clutch or clutch drum.
How to fix pinion damaged or worn on Stihl FS 410?
Replace set of pinions on the drive side and non-drive side.
What to do if cutting attachment out of true on Stihl FS 410 Brush Cutter?
Resharpen cutting attachment, replace if necessary.
What to do if screws of the clutch are loose on Stihl FS 410?
Tighten the screws. Replace the clutch if necessary and check the threaded holes on the flywheel, replacing the flywheel if needed.
How to fix broken tension springs of the clutch shoes on Stihl FS 410 Brush Cutter?
Replace tension springs.
What to do if starter rope can be pulled out almost without resistance on Stihl FS 410 Brush Cutter?
Replace pawls.
Why does the drive tube assembly on my Stihl FS 410 get very warm?
If the drive tube assembly becomes very warm, the drive shaft may not be sufficiently lubricated. Lubricate the drive shaft along its entire length, ensuring the entire length of the flexible liner is lubricated.
Fuel Tank Capacity | 0.75 L |
---|---|
Shaft Type | Straight |
Engine Power | 2.0 kW |
Displacement | 41.6 cc |
Overall Length | 180 cm |