Stihl GHE 250 - Technical specifications; Troubleshooting

0478 201 8313 B - EN
28
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Feed chute not properly closed - safety
cut-off switch actuated (motorstop)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (Ö 8.6)
– Check power cable and fuse
# (Ö 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) # (Ö 10.1)
– Close feed chute properly and tighten
screws (Ö 11.2)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(Ö 11.3)
– Reset locking device (Ö 11.4)
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades # (Ö 11.7)
16. Technical specifications
GHE 150.0/GHE 250.0/GHE 250.0 S:
Motor, design Electric motor
Power 2200 W
Amperage rating 10 A
Rated voltage 230 V~
Speed 2800 rpm
Main fuse
1
10 A
Frequency 50 Hz
Protection class I
Type of protection Splash proof
(IPX4)
Operating conditions P40
40 s load time
60 s idle time
GHE 150.0:
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L
WAd
99 dB(A)
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
pA
89 dB(A)
Uncertainty K
pA
2 dB(A)
Bolt tightening torques:
Blade disc 50 Nm
Reversible blade 10 Nm
Weight 27 kg
L/W/H 95/48/114 cm
GHE 250.0/GHE 250.0 S:
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L
WAd
103/100 dB(A)
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
pA
92/90 dB(A)
Uncertainty K
pA
3dB(A)
Bolt tightening torques:
Blade disc 50 Nm
Reversible blade 10 Nm
Shredding blades
2
10 Nm
Weight 29/28 kg
L/W/H 107/48/143 cm
1) Caution!
In the case of mains fuses of less
than 15 A, these may be tripped dur-
ing start-up or in the case of high
load operation of the machine.
2) For model GHE 250.0
17. Troubleshooting
# If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.