GS 461
English
17
On the ground
N Place the concrete cutter securely
on the ground – assume a steady
stance- the diamond abrasive chain
must not touch any objects or the
ground
N Press the concrete cutter firmly
against the ground, holding the front
handle with your left hand, thumb
wrapped round the handle
N Place your right foot into the rear
handle
Between the knees or thighs
N Clamp the rear handle between the
knees or thighs
N Grip the handlebar firmly with the
left hand – thumb wrapped around
the handlebar
Starting
N With the right hand, pull the starter
grip slowly until you feel it engage –
and then give it a brisk strong pull –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage! Do not let the starter grip
snap back – guide it vertically back
into the housing so that the starter
rope can rewind properly
Starting the concrete cutter
Before starting, open the shut-off valve
completely and ensure a supply of water
to the diamond abrasive chain – do not
allow diamond abrasive chain to run dry.
To Next Page
Loading...
