What to do if Stihl MS 341 Chainsaw shows resistance of approximately 8 Ohm?
If your Stihl Chainsaw shows a resistance of approximately 8 Ohm, check the thermostatic switch. Verify if the switch opens below +6 °C (43 °F) and also check if it opens above +14 °C (57 °F).
Covers basic safe operation, handling, and general precautions for the power tool.
Details necessary personal protective equipment (PPE) for safe operation.
Covers stopping, unattended operation, chain rotation, and general hazards.
Addresses risks from exhaust and ventilation needs during operation.
Details kickback, pushback, and pull-in reactions encountered during use.
Explains when kickback occurs and provides methods to avoid it.
Describes the pull-in phenomenon and how the saw reacts.
Explains the pushback phenomenon and how to avoid it.
Covers safe practices during cutting operations.
Precautions for elevated work to prevent falls and accidents.
Planning the tree's fall and establishing safe escape routes.
Clearing the felling site for secure footing and safe operation.
How to make the felling notch to guide the tree's fall.
Technique to prevent sapwood splintering when the tree falls.
Safety shouts and explanation of the hinge's role in controlling fall.
Specific felling technique suitable for smaller diameter trees.
Technique for cutting large diameter trees exceeding guide bar length.
Covers plunge and heartwood cuts requiring special training.
Techniques for challenging trees and safety for logs under tension.
How to safely remove branches from a felled tree.
Describes the ripping cut method and associated risks.
Describes effects of prolonged use on hands and potential health risks.
Advice on servicing, repairs, and using authorized dealers.
Safety step ensuring the engine is off before maintenance.
Steps for mounting the bar and chain with a side chain tensioner.
Steps for mounting the bar and chain with a quick chain tensioner.
Steps for installing the saw chain onto the sprocket and guide bar.
How to tension the saw chain using the side tensioner system.
How to tension the saw chain using the quick tensioner system.
Procedure to check the saw chain tension is correct.
How to verify proper chain oil flow and check oil level.
How to break in a new machine to ensure proper component seating.
Step-by-step guide for correctly sharpening the saw chain.
To Next Page
General
