Stihl GS 461 - Oil seal on ignition side

GS 461
English
24
Removing the fan housing
N Remove screws (1)
N Push the hand guard (2) upwards
N Pull the bottom of the fan
housing (3) away from the
crankcase and remove downwards
Replacing a torn starter rope
N Carefully press the spring clip (4) off
of the axle with a screw driver or
suitable pliers
N Remove washer (5)
N Remove the pawls (6)
N Remove the rope rotor (7)
N Lever the rope out of the starter
handle with a screwdriver
N Remove the remainder of the rope
from the rotor and starter handle
N Thread a new ElastoStart starter
rope from top to bottom through the
starter handle and
N Press the remaining rope into the
handle until the nipple is flush with
the handle
N Thread the starter handle with the
starter rope from top to bottom
through the rope guide bush (8)
N Pull the starter rope through the
rope rotor (7) and secure it with an
overhand knot
N Coat the bearing bore in the rope
rotor with non-resinous oil
N Slip the rope rotor onto the starter
post (9) – turn it back and forth a
little until the anchor loop of the
rewind spring engages
Replacing the Starter Rope
and Rewind Spring
1
1
1
1
2
3
2411BA034 KN
5
2411BA035 KN
4
6
7
6
213BA019 KN
8
7
2411BA036 KN