Stihl GTA 26 - Troubleshooting Guide; Garden Pruner and Battery

0458-694-8621-A
37
English 23 Troubleshooting Guide
23.1 Garden Pruner and Battery
23 Troubleshooting Guide
Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Garden Pruner
Possible Cause Remedy
Garden pruner does
not start when
switched on.
No electrical contact
between garden
pruner and battery.
► Remove the battery, @ 14.2.
► Visually check the electrical contacts in the battery
compartment and on the battery.
► Reinsert the battery, @ 14.1.
1 LED flashes
green.
Battery has low
charge.
► Charge the battery, @ 11.
1 LED glows
red.
Battery too hot / too
cold.
► Allow the battery to warm up or cool down gradually at
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
4 LEDs flash
red.
Malfunction in
battery.
► Remove the battery and reinsert it, @ 14.
► Switch on the garden pruner, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
3 LEDs glow
red.
Garden pruner too
hot.
► Allow the garden pruner to cool down.
3 LEDs flash
red.
Malfunction in
garden pruner.
► Remove the battery and reinsert it, @ 14
► Switch on the garden pruner, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The garden pruner has a malfunction and must be checked
by a servicing dealer.
Garden pruner cuts
out during operation.
1 LED glows
red.
Battery too hot / too
cold.
► Remove the battery, @ 14.2.
► Allow the garden pruner and battery to warm up / cool down
gradually at ambient temperatures of about 50 °F to 68 °F
(10 °C to 20 °C).
3 LEDs glow
red.
Garden pruner too
hot.