Stihl HS 75 - Weight; Special Accessories for the User; Catcher Plate; Service Accessories

 :HLJKW
(complete machine): HS 75/16" = 11.5 lbs.
HS 75/21" = 11.9 lbs.
HS 80/21" = 12.1 lbs.
HS 80/27" = 12.6 lbs.
HS 85/21" = 11.7 lbs.
HS 85/27" = 12.1 lbs.
HS 85/39" = 13.0 lbs.
* Cutter length
 6SHFLDODFFHVVRULHVIRUWKHXVHU
Catcher plate for HS 85 4226 740 3350
 6HUYLFHDFFHVVRULHV
 6SHFLDOWRROV
 7REHSXUFKDVHGIRUWKHILUVWWLPHIRUVHULHV+6
'HVLJQDWLRQ 3DUW1R 8VH 5HPDUNV
Axial face seal
Puller 5910 890 4400 Oil seals 1)
Spindle 5910 890 8400
1)
In the case of puller 0000 890 4400, the former spindle can be replaced by spindle 5910 890 8400,
which is 20 mm longer. The puller is then identical with puller 5910 890 4400.
 ([LVWLQJVSHFLDOWRROV
The usual special tools must be used for all other repair work (as for HS 72, 74, 76).
 $LGV
Carburetor parts kit 4133 007 1060 (WT 412) WALBRO
Carburetor parts kit 4226 007 1060 (C 1Q S-29) ZAMA
Gasket panel 0457 281 4203
 5HSDLUV
The national safety regulations and the safety instructions in the Instruction Manual must be observed if the
machine has to be started up during maintenance or repair work.
 7HVWYDOXHV
 /HDNDJHWHVW
3RZHUXQLW
Leakage testing of the crankcase:
under pressure: 0.5 bar
under vacuum: 0.5 bar
&DUEXUHWRU
Inlet needle testing
pressure: 0.6 bar
7HFKQLFDO,QIRUPDWLRQ3DJH