EasyManuals Logo

Stihl HT 103 User Manual

Stihl HT 103
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
HT 102, HT 103, HT 132, HT 133
English
15
HT 102, HT 132
Always hold the shaft with your left hand
in the area of the handle hose.
The shaft should always be held at an
angle of 60° or less.
The least tiring working position is a tool
angle of 60°.
Any lesser angle may be used to suit the
situation.
Cross-cut
To avoid pinching the bar in the cut,
position the cutting attachment with the
housing against the branch and then
perform the cross-cut from the top
downwards.
Relieving cut
To avoid tearing the bark on thick
branches, always start by performing a
relieving cut (1) on the underside of the
branch.
N To do this, apply the cutting
attachment and pull it across the
bottom of the branch in an arc as far
as the bar nose.
N Perform the cross cut (2) – position
the bar with the housing against the
branch.
Flush-cutting thick branches
If branch diameter is more than
10 cm (4 in), first
N perform undercut (3) and then
cross-cut at a distance of about
20 cm/8 in (A) from the final cut.
Then carry out the flush-cut (4),
starting with a relieving cut and
finishing with a cross-cut.
246BA030 KN
246BA032 KN
2
1
246BA033 KN
3
4
A
390BA024 KN

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl HT 103 and is the answer not in the manual?

Stihl HT 103 Specifications

General IconGeneral
BrandStihl
ModelHT 103
CategoryPole Saw
LanguageEnglish

Related product manuals