HT 75
English
23
Dirty air filters reduce engine power,
increase fuel consumption and make
starting more difficult.
Your power tool comes standard with
either a clip-on or screw-mounted filter
cover.
If there is a noticeable loss of engine
power
N Set the choke lever to g.
On the clip-on filter cover:
N Press in the tab (1) and swing the
filter cover (2) away.
On the screw-mounted filter cover:
N Loosen the screw (3) and remove
the filter cover (2).
On both versions:
N Clean away loose dirt from around
the filter.
N Remove the foam and felt filter
elements.
N Wash the foam element in a clean,
non-flammable solution (e.g. warm
soapy water) and then dry.
N Fit a new felt element – do not wash.
As a temporary measure you can
knock it out on the palm of your
hand or blow it out with compressed
air.
Replace any damaged parts.
N Fit the foam filter element (4) in the
filter cover.
N Place the felt element (5) (lettering
facing inwards) in the filter
housing (6).
N Fit the filter cover.
N Clip the filter cover in position or
tighten down the screw firmly.
Cleaning the Air Filter
To Next Page
Loading...
