To Next PageTo Next Page
Need help?Do you have a question about the Stihl KM 94 R and is the answer not in the manual?
General| Displacement | 27.2 cm³ |
|---|---|
| Power Output | 0.9 kW |
| Weight | 4.0 kg |
| Engine Type | 2-stroke |
| Fuel Tank Capacity | 0.35 l |
| Engine Power | 0.9 kW |
| Powerhead Weight | 4.0 kg |
| Fuel Capacity | 0.54 l |
Explains symbols attached or embossed on the machine.
Explains how instructions and procedures are marked in the manual.
Key safety precautions for operating the KombiEngine, including proper use and user restrictions.
Operator must be in good physical and mental health, not impaired by substances.
Wear appropriate protective apparel to reduce the risk of injury.
Never modify the tool; use only STIHL approved attachments for safety.
Shut off engine before transport, secure tool to prevent damage and spillage.
STIHL power tool uses a specific oil-gasoline mixture for optimal performance.
Refuel in well-ventilated areas, outdoors, after the engine has cooled down.
Crucial safety warnings related to maintenance and repair procedures.
Fit the barrier bar on the loop handle and secure it properly.
Adjust loop handle position for operator comfort and reach.
Identifies key controls like throttle trigger, stop switch, and set wheel.
Explains how the stop switch controls ignition and engine start readiness.
Describes how the throttle set wheel limits throttle trigger travel.
Avoid high loads during break-in to allow parts to bed in properly.
Idle engine after heavy use to dissipate heat and protect components.
Wait for engine cool, empty tank, store securely.
Procedure for cleaning or replacing the felt air filter.
Adjust idle speed to ensure the attachment does not rotate at idle.
Steps to safely remove the spark plug.
Inspect spark plug condition, gap, and use approved types.
Procedure for installing the spark plug correctly.
Check throttle cable for correct engine speed response.
Check spark arresting screen in muffler for low engine power.
STIHL recommends authorized dealers for servicing and repairs.
Inspect fuel pickup body annually and replace if necessary.
Check spacer for damage; replace shroud if damaged.
Check vibration element for wear or increased vibration.
Emission Compliance Period for Federal requirements.
Emission Compliance Period for California Air Resources Board.
This warranty statement is not for California models.
Explains EPA warranty rights and owner obligations for emission control.
Covers defects in emission-related parts for two years.
Owner is responsible for required maintenance and proper use.
Specific warranty statement for California models.
Explains CARB warranty rights and owner obligations for emission control.
Manufacturer warrants emission parts for two years in California.
Owner responsible for maintenance; warranty may be denied for abuse/neglect.
