–
Protection class: III
–
Degree of protection: IP56
–
Maximum mowing area:
–
iMOW
®
5.0: 1500 m²
–
iMOW
®
6.0: 3000 m²
–
iMOW
®
7.0: 5000 m²
–
Active time 1000 m² (per week)
1
–
iMOW
®
5.0: 50 h
–
iMOW
®
6.0: 35 h
–
iMOW
®
7.0: 30 h
–
Maximum length of the perimeter wire: 850 m
–
Maximum gradient: 40%
Bluetooth
®
–
Data connection: Bluetooth
®
5.1. The mobile
appliance must be compatible with Bluetooth
®
Low Energy 5.0 and support Generic Access
Profile (GAP).
–
Frequency band: ISM band 2.4 GHz
–
Maximum RF power transmitted: 1 mW
–
Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can vary
greatly depending on local conditions, includ‐
ing the receiver. The range may be perceptibly
reduced inside enclosed rooms and through
metal barriers (such as walls, shelves or
cases).
–
Mobile terminal operating system require‐
ments: See info.myimow.stihl.com
Radio network (WLAN)
–
Network standard: IEEE 802.11b/g/n
–
Frequency band: 2.4 GHz
–
Maximum RF power transmitted: 100 mW
23.2 Blades
–
Number of blades: 3
23.3 STIHL AAI battery
The battery has been installed in the robot
mower and must only be removed by a STIHL
authorized dealer.
–
Battery technology: lithium-ion
–
Voltage: 36 V
–
Capacity in Ah: see rating label
–
Energy content in Wh: see rating label
–
Weight in kg: see rating label
23.4 Docking station and power sup‐
ply
Docking station
–
Protection class: III
–
Degree of protection: IPX5
–
Weight: 4.0 kg
–
Perimeter wire and guide wire
–
Voltage: 42 V DC
–
Frequency range: 1.4 kHZ to 20 kHz
Power supply
–
Market-dependent versions:
–
DM160E-420A
–
DM160E-420AS
–
DM160K-420A
–
DM160S-420A
–
DM210E-420A
–
DM210E-420AS
–
DM210K-420A
–
DM210S-420A
–
Weight:
–
Version 160 W: 1.6 kg
–
Version 210 W: 2.0 kg
–
Rated voltage: See rating plate
–
Frequency: see rating plate
–
Rated power: see rating plate
–
Charging current: See rating plate
–
Protection class: II
–
Degree of protection: IP 67
23.5 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
–
Cord length up to 20 m: AWG 15 / 1.5 mm²
–
Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
If rated voltage on the rating label is 100V to
127V:
–
Cord length up to 10 m: AWG 14 / 2.0 mm²
–
Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
1
Under ideal conditions (few obstacles, simple geometry and low gradients in garden, moderate
growth of lawn)
23 Specifications English
0458-011-0101-A 43
To Next Page
Loading...
Need help?
General
