Stihl KM 55 - Page 13

12
English / USA
KM 55
Fitting the control handle
: Release the screw (8) and remove it
with the washer. The nut (9) remains
in the control handle (10).
: Push the control handle onto the
handlebar (4) – the throttle trigger
(11) must point towards the
gearhead.
: Line up the holes (12).
: Fit screw and washer in control
handle and tighten down firmly.
* see “Guide to Using this Manual”
Fitting the throttle cable
Do not kink the throttle cable - make
sure the throttle trigger moves freely.
: Push the throttle cable (13) into the
retainer (14).
Loop handle with barrier bar
: Insert square nuts (1) in the
barrier bar (2).
: Line up the holes.
8
10
11
4
12
233BA038 KN
12
9
14
13
14
13
233BA027 KN
Mounting the Loop Handle
2
002BA098 KN
1
1