MS 171, MS 171 C, MS 181, MS 181 C, MS 211, MS 211 C
English
32
Starting
Standard versions
N with the right hand, pull the starter
grip slowly until you feel it engage –
and then give it a brisk strong pull –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage! Do not let the starter grip
snap back – guide it vertically back
into the housing so that the starter
rope can rewind properly
With a new engine or after a long period
of disuse, with machines without an
additional manual fuel pump, it may be
necessary to pull the starter rope several
times – to prime the fuel line.
Versions with ErgoStart
WARNING
This machine is extremely simple and
easy to start, even for children – risk of
accident!
Make absolutely certain that children or
other unauthorized persons cannot
attempt to start the machine:
– never leave the machine
unattended during work breaks
– secure storage after work
The ErgoStart stores the energy for
starting the chain saw. For this reason, a
few seconds may pass between the
pulling of the starter rope and the
starting of the engine.
For versions with ErgoStart, there are
two ways to start the machine:
N pull the starter grip slowly and
smoothly – or – with the right hand,
pull the starter grip in several short
pulls of the starter rope, pulling the
rope out only a little bit each time
N during starting, press down on the
handlebar – do not pull out the
starter rope all the way – risk of
breakage!
N Do not let the starter grip snap back
– guide it vertically back into the
housing so that the starter rope can
rewind properly
Starting the chain saw
WARNING
There must not be anyone within the
swivel range of the chain saw.
N Observe safety precautions
Versions with fuel pump
N Press the fuel pump bulb at least
five times – even if it is still full of fuel
To Next Page
Loading...
Need help?
General
Weight and Dimensions
