Stihl MS 192 T User Manual

30
English / USA
MS 192 T, MS 192 TC
: Place your saw on the ground.
: Make sure you have a firm footing –
check that chain is not touching any
object or the ground.
Bystanders must be well clear of the
general work area of the saw.
: Hold the saw firmly with your right
hand on the top handle and your
right knee on the filter cover.
Models with standard starter:
: Pull the starter grip slowly with your
left hand until you feel it engage –
and then give it a brisk strong pull
and push down the handle at the
same time.
: Do not pull out starter rope all the
way because it might otherwise
break.
: Do not let the starter grip snap back
– guide it slowly and vertically into
the housing so that the starter rope
can rewind properly.
Models with Easy2Start:
The Easy2Start stores the energy
required to start the saw. en der
Motorsäge. For this reason there may a
delay of a few seconds between
cranking the engine and it actually
starting.
There are two ways of starting with the
Easy2Start:
: Hold the starter grip with your left
hand and pull it out slowly and
steadily
or:
Hold the starter grip in your left hand
and and give it several short pulls,
using only a short length of rope for
each pull..
: Push down the handle while
cranking. Do not pull out the starter
rope to its full length – it might
otherwise break.
: Do not let the starter grip snap back
– guide it slowly and vertically into
the housing so that the starter rope
can rewind properly.

Stihl MS 192 T Specifications

General

Engine Displacement	30.1 cc
Recommended bar length	30 cm
Engine Power	1.3 kW
Guide Bar Length	30-35 cm
Fuel Capacity	0.27 liters
Chain Oil Capacity	0.22 liters
Chain pitch	3/8"