Stihl MS 200 T User Manual

29MS 200 T
English / USA
The four positions of the
Master Control lever
0 = Engine off –
ignition is switched off.
# = Normal run position –
engine runs or can fire.
To move the Master Control lever from #
to
n or l, press down the throttle
trigger interlock and squeeze throttle
trigger at the same time.
n=Warm start – this position is used to
start a warm engine. The Master
Control lever moves to the normal
run position as soon as the throttle
trigger is squeezed.
l=Cold start – this position is used to
start a cold engine.
: Observe safety precautions.
: Push hand guard (1) forward:
The chain is now locked.
: Press throttle trigger interlock (2)
and set Master Control lever to:
for cold start l
for warm start n
(even if engine has been running
but is still cold).
: Place your saw on the ground.
Make sure you have a firm footing -
check that chain is not touching any
object or the ground.
Bystanders must be well clear of the
general work area of the saw!
: Hold the saw firmly on the ground
with your right hand on the top
handle and your right knee resting
on the carburetor box cover.
Information
Before You Start
STOP
0
001BA140 KN
Starting / Stopping
the Engine
142BA026 LÄ
142BA070 KN

Stihl MS 200 T Specifications

General

Brand	Stihl
Model	MS 200 T
Category	Chainsaw
Language	English