Stihl MS 211 C-BE User Manual

Simultaneously pressing the throttle trigger lock‐
out and blipping the throttle trigger causes the
master control lever to jump from the warm
start n position to the operating position F.
To switch off the engine, set the master control
lever to Stop 0.
18.2.1
Position choke shutter closed l
–
if the engine is cold
–
if the engine stalls during opening of throttle
after starting
–
If the fuel tank has run empty (engine stalled
out)
18.2.2
Position starting acceleration n
–
if engine is warm (once the engine has been
running for approx. one minute)
–
When the engine has turned over for the first
time
–
after ventilation of the combustion chamber, if
the engine was flooded
18.3 Fuel pump
Press the fuel pump bulb several times – even if
it is still full of fuel:
–
When starting for the first time
–
If the fuel tank has run empty (engine stalled
out)
18.4 Holding the chain saw
There are two ways to hold the chain saw during
starting.
18.4.1 On the ground
143BA018 KN
► Place the chain saw securely on the ground –
assume a steady stance – the saw chain must
not touch any objects and also must not touch
the ground
► With the left hand on handlebar, press the
chain saw firmly against the ground – thumb
wrapped around the handlebar
► Place your right foot through the rear handle
18 Starting / Stopping the Engine English
0458-533-0121-E 27

Stihl MS 211 C-BE Specifications

General

Displacement	35.2 cm³
Power output	1.7 kW
Oilomatic chain type	Picco Micro 3 (PM3)
Guide Bar Length	35 cm
Chain pitch	3/8"