The following maintenance intervals apply for normal operat‐
ing conditions only. When working under difficult conditions
(high accumulation of dust, highly resinous lumber, lumber
from tropical trees, etc.) or longer than normal each day, the
specified intervals must be shortened accordingly. If you only
use the tool occasionally, extend the intervals accordingly.
Before starting work
At the end of work and/or daily
Whenever tank is refilled
Weekly
Monthly
Annually
If faulty
If damaged
As required
Chain lubrication check X
Saw chain Check, pay attention to
sharpness
X X
Checking the chain tension X X
sharpen X
Guide bar Check (wear, damage) X
Clean and turn over X
Deburr X
replace X X
Chain sprocket check X
Air filter Clean X X
replace X
Anti-vibration elements check X X
Have replaced by servicing
dealer
1)
X
Air intake on fan housing Clean X X X
Cylinder fins Clean X X X
Carburetor Check idle adjustment – saw
chain must not rotate
X X
Set the idle speed; if required
have the chainsaw repaired
by a specialist dealer
1)
X
Spark plug Adjust electrode gap X
Replace after 100 hours of
operation
Accessible screws and nuts
(except adjusting screws)
Tighten
2)
X
Chain catcher check X
replace X
Safety information label replace X
1)
STIHL recommends STIHL servicing dealer
2)
When using professional chainsaws (with a power output of 3.4 kW or more) for the first time,
tighten the cylinder block screws after 10 to 20 hours of operation
English 30 Maintenance and Care
40 0458-533-0121-E
To Next Page
Loading...
Need help?
General
