Stihl MS 461

MS 461 R
English
31
For retensioning during operation:
N Switch off the engine
N Put on protective gloves
Versions with depth limiter (special
accessory)
N Loosen adjusting screw (1)
N Push the slide (2) toward the engine
as far as it will go
N continue with "For all versions"
For all versions
N Loosen nuts
N Raise the guide bar at the nose
N Use the screwdriver to turn the
screw (1) to the right until the saw
chain rests against the underside of
the guide bar
N Raise the guide bar further and
tighten the nuts securely
N Continue with "Checking the chain
tension"
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period!
N Check chain tension frequently –
see "Operating Instructions"
N Switch off the engine
N Put on protective gloves
Versions with depth limiter (special
accessory)
N Loosen adjusting screw (1)
N Push the slide (2) toward the engine
as far as it will go
N continue with "For all versions"
Tensioning the Chain
1
3443BA033 KN
2
1
Checking Chain Tension
1
3443BA033 KN
2