How to start a Stihl Chainsaw that won't start?
If the engine of your Stihl chainsaw does not start, the issue might be due to insufficient fuel in the tank. In this case, mix fuel and refuel the chainsaw. Alternatively, the engine could be flooded. If so, clear the combustion chamber.
What to do if Stihl Chainsaw chain does not rotate?
If the saw chain on your Stihl chainsaw does not rotate when the throttle is opened, the chain brake may be engaged, so disengage the chain brake. The chain could be over-tensioned, so tension the chain properly. Another possibility is that the bar nose sprocket is blocked; clean it with STIHL resin solvent.
How to start a Stihl Chainsaw when the engine won't start?
If your Stihl Chainsaw engine isn't starting, there might not be enough fuel. Mix fuel and refuel the chainsaw. Alternatively, the engine could be flooded, in which case you should clear the combustion chamber.
What to do if the Stihl Chainsaw chain does not rotate when the throttle is opened?
If the Stihl Chainsaw chain isn't rotating when you open the throttle, it could be due to a few reasons. First, the chain brake might be engaged, so disengage the chain brake. Second, the chain might be over-tensioned, so tension the chain properly. Lastly, the bar nose sprocket could be blocked, so clean the bar nose sprocket with STIHL resin solvent.
Why does my Stihl MS 500i emit smoke or a burning smell when cutting?
If your Stihl Chainsaw is emitting smoke or a burning smell while cutting, several factors could be at play. The chain might not be properly sharpened, so sharpen the chain properly. There might be insufficient chain oil in the tank, so fill up with chain oil. The chain lubrication system could be supplying insufficient chain oil, so increase the oil feed rate. The chain may be over-tensioned, so tension the chain properly. Finally, the chainsaw might not be used properly, so have correct use explained, then practice.
Why does my Stihl MS 500i have a burning smell?
If your Stihl chainsaw is producing smoke or a burning smell while cutting, several factors could be responsible. The chain might not be properly sharpened, so ensure you sharpen the chain properly. There might be insufficient chain oil in the tank, so fill it up with chain oil. The chain lubrication system may not be supplying enough oil; in this case, increase the oil feed rate. Also, the chain could be over-tensioned, so make sure to tension the chain properly. Finally, ensure that the chainsaw is being used correctly; have its correct use explained and then practice.
Why does my Stihl MS 500i Chainsaw have poor acceleration?
If your Stihl chainsaw has poor acceleration, it could be due to the chain being over-tensioned. Ensure you tension the chain properly. Another possible cause is that the chain lubrication system is supplying insufficient chain oil, so increase the oil feed rate.
Why is the acceleration poor on my Stihl MS 500i Chainsaw?
Poor acceleration on your Stihl Chainsaw can stem from a couple of issues. The chain might be over-tensioned, so tension the chain properly. Alternatively, the chain lubrication system might be supplying insufficient chain oil, so increase the oil feed rate.
Specifies the approved applications for the chain saw and prohibits misuse.
Details essential protective gear for safe chain saw operation.
Covers avoiding fuel spraying and proper fuel cap removal/installation.
Introduces reactive forces and their potential to cause injury.
Explains kickback, its causes, and potential for severe injury.
Provides practical steps to prevent kickback situations.
Addresses the increased dangers of cutting logs with internal tension.
Continues felling back cut instructions, including hinge management and wedge use.
Details maintenance for cutting performance and safety, including chain brake care.
Details how to properly tension the chain for safety and performance.
Continues lubricant advice and introduces filling the chain oil tank.
Continues engaging the chain brake and introduces disengaging.
Covers fuel handling safety, container use, and proper mixing steps.
Continues refueling instructions, covering cap removal, filling, and avoiding fuel spray.
Continues engine starting instructions, including rope handling and chain brake engagement.
Continues chain brake checks and introduces testing controls.
Explains how to check if the chain oil is being delivered properly.
General| Idle speed | - RPM |
|---|---|
| Motor type | 2-stroke motor |
| Chain pitch | 3/8 \ |
| Blade length | 710 mm |
| Product color | Black, Grey, Orange |
| Chain tensioner | Yes |
| Engine displacement | 79.2 cm³ |
| Power source | Gasoline |
| Sound power level | 119 dB |
| Vibration emission | 4.2 m/s² |
| Sound pressure level | 106 dB |
Weight and Dimensions| Weight | 6200 g |
|---|
To Next Page
