MS 241 C-M
English
34
When the mounting kit is used, the
shutter must be in the winter position.
If engine trouble occurs, first check
whether use of the cover plate is
necessary.
Positions of the Master Control lever
Stop 0 – engine off – ignition is switched
off
Run F – Engine running or can start
Start } – this position is for starting the
engine
Adjusting the Master Control lever
To adjust the Master Control lever from
run F to start }, press and hold down
the throttle trigger lockout and throttle
trigger simultaneously – set Master
Control lever to start } and
simultaneously release the throttle
trigger and throttle trigger lockout.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the Start } position to
run F.
Holding the chain saw
There are two ways to hold the chain
saw during starting.
Starting / Stopping the
Engine
To Next Page
Loading...
