MS 241 C-M
English
41
N If engine performance deteriorates,
check the spark arresting screen in
the muffler
N Let the muffler cool down
N Unscrew the screw (1)
N Pull out spark arresting screen (2)
N Clean the dirty spark arresting
screen, replace if damaged or
heavily carbonized
N Refit the spark arresting screen
N Fit screw
Removing the spark plug
N Remove the shroud – see "Shroud"
N Pull off the spark plug boot
N Unscrew spark plug
Checking the Spark Plug
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see
"Specifications."
N Use only resistor type spark plugs of
the approved range.
Rectify problems that have caused
fouling of spark plug:
– too much oil in fuel mix,
– dirty air filter,
– unfavorable running conditions, e.g.
operating at part load.
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press spark plug boot (1)
snugly onto spark plug terminal (2) of the
proper size. (Note: If terminal has
detachable SAE adapter nut, it must be
securely attached.) A loose connection
between spark plug boot and ignition
wire connector in the boot may create
arcing that could ignite combustible
fumes and cause a fire.
Spark Arresting Screen in
Muffler
Spark Plug
To Next Page
Loading...
Need help?
General
