Stihl RM 448 T User Manual

ENSK
19
TRHUSRHRCSLVLTROELBGETAZKK
0478 111 9841 A - EN
RM 443, RM 443 T, RM 448 PT,
RM 448 T, RM 448 TX:
RM 448 PC, RM 448 TC, RM 448 VC:
7.1 General
● Place the machine on level and firm
ground when performing all the
operations described.
7.2 Installing the mono handlebar
(RM 448 PC, RM 448 TC,
RM 448 VC)
● 1 Insert sleeve (I) in the bore on
handlebar (1).
● 2 Fit the two washers (K) with the
convex side facing inwards onto the
sleeve in handlebar (1).
● 3 Hold sleeve (I) and washers (K) and
insert together with handlebar (1) into
the holder on handlebar bracket (2).
● 4 Insert bolt (J) from the outside
inwards through the bores in
handlebar (1) and in handlebar
bracket (2).
● 5 Screw on nut (L).
● 6 Tighten bolt (J). Tightening torque:
18 - 22 Nm
Risk of injury!
Keep your hands and feet
away from the blades.
Cutting tool runs on for sev-
eral seconds after switching
off (engine/blade brake).
RM 443, RM 443 T,
RM 448 PT, RM 448 T,
RM 448 TX:
Starting the engine
RM 443, RM 443 T,
RM 448 PT, RM 448 T,
RM 448 TX:
Stopping the engine
RM 443 T, RM 448 PT,
RM 448 T, RM 448 TX:
Switching on self-propulsion
RM 448 PC, RM 448 TC,
RM 448 VC:
Starting the engine
RM 448 PC, RM 448 TC,
RM 448 VC:
Stopping the engine
RM 448 PC, RM 448 TC,
RM 448 VC:
Switching on self-propulsion
RM 448 VC:
Set the driving speed.
(Ö 11.3)
6. Standard equipment
Item Designation Qty.
A Basic unit 1
B Upper part of grass catcher
box
1
C Lower part of grass catcher
box
1
D Pin 2
– Instruction manual 1
– Instruction manual
for engine
1
Item Designation Qty.
E Quick-clamping device 2
F Bolt 2
G Cable guide 2
H Protective sleeve 2
2
Item Designation Qty.
I Sleeve 1
J Bolt 1
K Washer 2
L Nut 1
7. Preparing the machine for
operation
Risk of injury!
Observe the safety instructions in
the section "For your safety" (Ö 4.).
3

Stihl RM 448 T Specifications

General

Brand	Stihl
Model	RM 448 T
Category	Lawn Mower
Language	English