0478 192 9809 A - EN
52
To relieve the weight on the rear wheels,
support the ride-on mower at the rear
panel:
B = at least 120 mm
Removing the wheel:
Remove the cap (1). Remove the retaining
ring (2) using a screwdriver.
Pull the large washer (3) and small
washer (4 – on the rear wheel only)
together with the wheel (5) off the wheel
axle.
Installing the wheel:
● Remove dirt from the wheel axle.
● Lightly coat the wheel axle with grease
before installation.
Insert the feather key (6) in the rear wheel
axle. Push the wheel (5 – valve facing
outwards) with the small washer (4 – on
the rear wheel only) and the large
washer (3) onto the wheel axle.
Allow the retaining ring (2) to engage in the
groove on the wheel axle.
Fit the cap (1) onto the wheel axle.
15.16 Tyre pressure
Avoid damage to the machine.
When removing the rear wheels,
ensure that the couplers (feather
keys) are not lost.
Avoid damage to the machine.
Before installing the rear wheels,
ensure that the couplers (feather
keys) are correctly positioned in the
groove of the wheel axle.
Correct tyre pressure is an
important prerequisite for alignment
of the mowing deck and
consequently for a clean cutting
pattern.
Moreover, the turf may be damaged
by the tyre studs in the case of
excessively high tyre pressure.
To Next Page
Loading...
