SR 200
English
24
N Close the valve lever.
N Shut off the engine – see "Starting /
Stopping the Engine".
Draining the Solution Container
N Turn metering knob (1) to 6.
N Open the valve lever and drain
remaining solution into a suitable
container.
Cleaning the Solution Container
N Rinse and clean the solution
container and hose system with
clear water.
N Dispose of remaining spray solution
and rinsing liquid in accordance with
local environmental requirements –
follow maker's instructions.
N Allow the unit to dry with the cap
removed.
If strainer is dirty:
N Insert a suitable tool (e.g.
screwdriver) in the two recesses
(arrows) to loosen the strainer (2).
N Pull the strainer (2) upward and out
of the solution container.
N Clean the strainer (2) with clear
water and a brush.
N Store the machine in a dry, high or
locked location sheltered from frost
– out of the reach of children and
other unauthorized persons.
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Do not expose the container to
direct sunlight for unnecessarily
long periods. UV rays can make the
container material brittle, which
could result in leaks or breakage.
After Finishing Work
Storing the Machine
To Next Page
Loading...
