18
English / USA
SR 340, SR 420
Before fueling, clean the filler cap and
the area around it to ensure that no dirt
falls into the tank.
Always thoroughly shake the mixture in
the canister before fueling your
machine.
In order to reduce the risk of burns
or other personal injury from
escaping gas vapor and fumes,
remove the fuel filler cap carefully
so as to allow any pressure build-up
in the tank to release slowly.
After fueling, tighten fuel cap
as securely as possible by hand.
Change the fuel pick up body
every year.
Before storing your machine for a long
period, drain and clean the fuel tank and
run engine until carburetor is dry.
With the engine stopped and before
starting, check the air intakes
between the backplate and
powerhead for blockages and clean
if necessary.
A protective screen is available as a
special accessory to keep the air
intakes clear.
The throttle cable disconnects itself from
the throttle trigger if the engine is not
shut off in the idle position.
The throttle cable reconnects itself
automatically when the setting lever is
moved to the idle position.
: Move the setting lever to the idle
position.
Fueling
373BA030 KN
373BA007 KN
Information
Before You Start
373BA037 KN
To Next Page
Loading...
