12
- Rotate the control handle (10) to the left (counterclockwise)
until it is horizontal.
- Rotate the extension tube 12 to the left (counterclockwise)
until the metering unit (13) points in the same direction as
the control handle.
- Tighten the clamp screw (11). (Observe instructions in
chapter "Adjusting the control handle")
- Push the free end of the liquid hose (14) over the stub on
the stop cock (15) and secure in position with the hose clip
(16).
- Secure liquid hose to the pleated hose with the retainer (5).
- Close the stop cock (move lever to vertical position).
Fill up with spray mix and check all hose connections for
leaks.
To Next Page
Loading...
