Still RCE 30 - Drivers Cab; Checking the Pedal Group for Ease of Movement and Lubricating as Required; Checking Other Bearings and Connections and Lubricating

Driver's cab
Checking the pedal group for
ease of movement and lubricat-
ing as required
– Remove the rubber mat from the floorplate.
– Remove the floorplate.
– Check bolt and joint fastenings for secure
positioning.
– Lightly oil the bearing, if necessary.
– Test functionality of the tension springs.
– Use lubricant to lubricate the contact face of
the pedal.
NOTE
Refer to the " Recommended fuels and oils
table
" for oil types.

Checking other bearings and connections and lubricating
ENVIRONMENT NOTE
Follow recommendations regarding the use of
consumables.
– Check and lubricate the following bearings
and fasteners.
●
Driver's seat guide.
●
Windscreen wiper bearings (special equip-
ment)
Other cleaning and lubricating
Performing maintenance every 1000 operating
hours is generally sufficient when operating in
a clean and dry internal environment. If used
both indoors and outdoors, cleaning / lubricat-
ing is recommended between 500 and 1000
operating hours, or at least every 12 months.
Maintenance
5
Driver's cab
 156 5001 801 1627EN-03/2023 - 03