IMPORTANT INFORMATION
AIR SUPPLY AND CONNECTIONS
• Use only clean, regulated compressed air as a power source for this tool.
Do not use bottle gases, combustible gases or oxygen as a power source
for the tool as the tool may explode.
• Do not use air supply pressures that exceed 110 PSI. Exceeding the
recommended maximum operating air pressure will greatly increase
tool wear.
• The air supply must be capable of maintaining the operating air pressure
of the tool. Pressure drops in the air supply can reduce tool performance.
• Use a pressure regulator and gauge to allow visual inspection of the air
pressure being delivered to the tool.
• Use air hoses that have rated pressures of up to 150% of the maximum
pressure that can be generated by the power source. The supply hose
should contain fittings that will provide quick disconnecting from the male
plug on the tool.
• Use quick connect fittings that allow the tool to be unhooked from the air
supply quickly and easily.
• Do not use fittings that will not allow the tool to exhaust when the air
supply is disconnected.
2
To Next Page
Loading...
