IMPORTANT INFORMATION
PERSONAL SAFETY ITEMS
• Do not use tool prior to reading the Owner’s Manual
• Always wear eye protection that conforms to ANSI requirements
(Z87.1) and provides protection against flying particles both from
the front and side. Eye protection should be worn by the operator
and by others in the work area. Eye protection is required to
protect against flying fasteners and debris that could possibly
cause severe eye injury.
• The employer is responsible to enforce the use of eye protection
equipment by the tool operator and all other personnel in the work
area.
• To prevent accidental injuries
- Handle the tool with care
- Always assume that the tool contains fasteners
- Always disconnect the air hose from the CN100B when:
• loading nails and/or caps
• performing inspection, maintenance or repair
• clearing a nail or collated cap jam
• the tool is not in use
• leaving the work area
• moving the CN100B to another work location
• handing the CN100B to another person
• storing the tool
- Never point the tool toward yourself or anyone else
- Never engage in horseplay when handling the tool
- Never hold or carry the tool with a finger on the trigger
- Never place a hand or any other part of the body in
the fastener discharge area of the tool while the air supply
is connected
1
To Next Page
Loading...
