Installation (Cont.)
Drain hose installation
The condenser dryer produces condensate water, which you can collect in the in-built
condensate container, or drain into a nearby sink using an external drain hose and
holder (supplied).
• To install the drain hose, follow the pictorial instructions in Fig. 3, below.
• Use pliers to remove the in-built drain hose from the hose connector at the back of
the appliance, then install the external drain hose.
• Using the supplied hose holder, lead the end of the drain hose into a sink at a
maximum height of 120cm.
Electrical connection
• This is a Category I electrical product.
• Once the clothes dryer is properly installed, plug the electrical cord into an
appropriately earthed three pin wall socket, switch on power at the socket and try
the machine (see page 17 for usage instructions).
Fig. 3
To Next Page
Loading...
