Instructions
Trial run
In order to remove any dust and grease, which may be in the drum from the
manufacture and transportation process, we recommend you run the dryer with some
clean rags before using it for the first time with your laundry. Maker sure the dryer is
properly connected and power is switched on at the outlet.
• Put some clean rags into the drum.
• Press the POWER button and select the “Quick” program.
• Press the START/PAUSE button and let the program run to the end.
• Remove the rags and clean the lint filter (see page 23).
Using the dryer
Starting up
• Make sure the dryer is properly installed, plugged in and power is supplied.
• Open the door and load the dryer following the guidelines on page 14.
– The total weight of the load to be dried should not exceed 7kg.
– Textiles made of wool or silk are NOT suitable for drying in the clothes dryer.
• Close the door and ensure that no items are caught in the door.
• Press the POWER button. The LED display screen illuminates.
Selecting the program and function
• Rotate the PROGRAM SELECTION dial to select the desired drying program.
Always check your clothes labels for recommended drying times and temperatures.
• If you want to use one of the speciality functions (Delay, Time, Intensity, Speed Dry,
Signal or Anti-Crease), press the respective button on the control panel (see pages
18–19 for a description of the functions). The buzzer will beep twice if the function
is unavailable.
• Press the START/PAUSE button. When the program starts, the drum will start
rotating. On the digital display, the respective cycle phase status will be flashing in
sequence and the remaining time will be illuminated.
At the end of the program
• The drum will stop rotating and a buzzer will beep several times at the end of the
program (unless you have turned off the signal function). The display will show
“0:00“ and the last cycle phase status light will flash.
• The dryer will automatically start the Anti-Crease function, unless you open the
door and remove the load within 1 minute (see page 19 for more on this function).
• Press the POWER button and unplug the dryer from the power supply.
• Open the door and take out the dry clothes.
• After every use, clean the filter and empty the condensate container, if applicable.
NOTE: If there is an unexpected stop during the drying procedure and the dryer
displays an error code, please refer to page 22 for more information.
To Next Page
Loading...
