Instructions (Cont.)
Speciality functions
In addition to the drying program, you can select various other functions using the press
buttons on the control panel after you have selected a program.
Delay
This function is used for delaying the start of your drying program by up to 24 hours.
The delay time is the period of time (in hours) after which the program will start. When
the delay program starts, the delay icon will blink on the display and the time will start to
decrease. To set a delayed start:
• Load your laundry and make sure the dryer door is closed.
• Press the POWER button, then rotate the PROGRAM SELECTION dial to select the
desired drying program.
• If desired, press the respective buttons to select other speciality functions, such as
ANTI-CREASE or INTENSITY.
• Press the DELAY button, repeatedly, to select the desired delay time.
• Press the START/PAUSE button. The dryer is now in operation and the delay start
symbol will flash on the display. The drying procedure will be performed automatically
when the delay time is over.
• To pause the delay function, press the START/PAUSE button again.
• To cancel the delay function, press the POWER button.
Time
This button lets you set the operating time in 10 minute steps for the “Warm” (max.
2:00 hours), “Cool” (max. 30 minutes) or “Refresh” (max. 2:30 hours) programs.
• Select the “Warm”, “Cool” or “Refresh” program, then press the TIME button,
repeatedly, to set the desired operating time.
Intensity
Use this function to adjust the dryness level of the load to be dried. The level has four
grades and in each grade, the drying time increases by 3 minutes. This function can only
be activated before the program start.
• Select the required program, then press the INTENSITY button, repeatedly, to select
the desired drying intensity.
NOTE: The INTENSITY function cannot be selected for the “Cotton-Iron”, “Quick”,
“Baby Care”, “Warm”, “Cool” and “Refresh” programs.
Speed dry
This function lets you shorten the drying time for the following 4 programs: “Cotton-
Extra”, “Cotton-Standard”, “Special-Bed Linen”, “Special-Jeans”.
• Select the required program, then press the SPEED DRY button to select the
shortened drying time.
To Next Page
Loading...
