13
AUS
AFTER SALES SUPPORT
MODEL: STR-E15BGD PRODUCT CODE: 708548 10/2022
1300 112 534
tempo.org/support
IMPORTANT!
• Ensure there is water in the tank before you start extracting espresso or
frothing milk.
• Monitor the water level during use to ensure there is always some water in
the tank. If you leave refilling until the tank is empty, the pump may start
sucking in air from the empty water tank.
Getting Started (Cont.)
Filling the water tank
Fill the water tank before switching on the espresso machine. The tank is
removable for easy filling.
1. Remove the lid of the water tank.
2. Grasp the water tank at the back of the machine and lift it up and off the unit to
fill the tank under the tap.
3. Fill the tank with cold tap water – never use warm or hot water. Replace the
water every day, or whenever you want to use the machine.
4. Rinse the tank and discard the water.
5. To prepare the machine for priming the pump, fill the tank again with cold water
to the MAX mark, then slide the full tank back into its original position. Reattach
the lid.
Alternatively, use a jug and carefully pour water into the opening while the tank is in
place on the base of the machine, then reattach the lid.
Priming the pump
Before first use, please take the time to thoroughly flush the inside of the espresso
machine, as described below. This simple step will ensure optimum dispensing.
1. Place the machine on a level surface, close to a sink to discard water.
2. Put the double shot filter basket – without any ground coffee – firmly into
the portafilter until it clicks securely into place.
3. Engage the portafilter onto the group head (refer to page 18, Fig. 11). Make
sure it is properly locked in place.
4. Centre a larger cup or mug under the portafilter. Place the steam wand’s tip
into the frothing jug.
To Next Page
Loading...
