29
AUS
AFTER SALES SUPPORT
MODEL: STR-E15BGD PRODUCT CODE: 708548 10/2022
1300 112 534
tempo.org/support
Steam wand and water dispenser
• Clean the nozzle thoroughly. If required, use the supplied
cleaning pin to clear any deposits. Insert the pin’s larger
wire into the nozzles to clear blockages in the nozzles
(Fig. 17). Rinse well.
• NOTE: Every 2-3 months, soak the steam wand overnight
in the milk jug with warm water and a descaling agent.
In the morning, thoroughly rinse the jug and steam
Other Useful Information (Cont.)
Grinder
• Empty the bean hopper. To completely clear it, insert the portafilter (with a filter
inserted) under the grinder and press the handle downwards to activate the mill
(without any beans) to remove any remnants. Once no more grinds fall, stop
grinding.
• Remove the bean hopper by turning the grind selector as far as it will go in an
anticlockwise direction, until it reaches the unlocked position (aligned with the
GRIND SIZE marking).
• Lift the upper part of the grinder.
• Clean the inside of the appliance with a soft cloth, wiping up any ground coffee
remnants. Never use a damp or wet cloth to clean the grinder.
• Insert the grinder back onto the appliance, following the steps on page 15.
Housing and fixtures
• Wipe the exterior housing and the area around the group head with a damp cloth.
WARNING: Never use solvents or any detergents that may scratch or damage
the surface of the machine.
• The gasket area around the group head may need to be brushed out
occasionally in order to remove coffee grounds.
Drip tray
• Always empty the drip tray in good time. After use, pull the drip tray straight
out of the appliance for emptying and cleaning.
• Remove the draining plate and empty any water out of the drip tray. You can
also remove the grounds compartment and dispose of the coffee grounds.
• Clean the tray, plate and grounds compartment with warm, soapy water.
Make sure that you do not damage the floater mechanism. Rinse well.
• Dry all parts with a clean cloth and reassemble.
Fig. 17
wand, ensuring all traces of the descaling agent have been removed. Purge
the steam wand for 4-5 seconds once reattached before steaming milk or
dispensing water.
To Next Page
Loading...
