30
AUS
AFTER SALES SUPPORT
MODEL: STR-E15BGD PRODUCT CODE: 708548 10/2022
1300 112 534
tempo.org/support
IMPORTANT!
Do not wash any parts or accessories of the espresso machine in the dishwasher.
Other Useful Information (Cont.)
Water tank
• Remove the water tank and turn it upside down over a sink to discard any water
left inside. We recommend you empty the water tank between uses and before
cleaning the appliance.
• Rinse the water tank thoroughly before filling it with fresh water for use.
• Also check the valve seal at the base of the water tank regularly and, if necessary,
carefully remove any dirt or limescale deposits, which could cause leaks.
Accessories
• Handwash the frothing jug and tamper in warm, soapy water. Rinse and dry.
Removal of mineral deposits
From time to time, you may need to clean off any mineral deposits (limescale) left by
water inside your espresso machine to keep it operating efficiently. How often you
have to do this depends on the water hardness in your area and on your frequency
of use. When the descale warning appears on the screen, please descale the
espresso machine as soon as possible.
Other indications that it is time to descale the machine is if you start noticing that
it takes longer to pull an espresso, if the machine is steaming excessively, or if you
notice a build-up of white deposits on the surface of the group head.
Short descale
1. Put a container of at least 2.3 L underneath the portafilter and steam wand.
Alternatively, use two smaller containers (one underneath the portafilter, the
other underneath the steam nozzle) and empty them as the machine alternates
its water dispersal.
2. Press the DESCALE button. It will illuminate. The descale icon will appear on
the display.
3. Fill the water tank with a commercially available descaling agent, and the
amount of water recommended on the packaging.
4. Press the START/STOP button to start the descaling process.
5. The until will start pumping continuously for three cycles, dispersing water for
40 seconds from the portafilter and for 40 seconds from the steam nozzle each
cycle.
6. Run a second descale cycle of clean water through the machine before use.
Ensure the water is completely clean before pulling espresso, dispensing water,
or using the steam wand, and, if not, run through another tank of clean water.
To Next Page
Loading...
